Getting ready mate my trans and motor. Had it out to seal some leaks and clean it off...
When I was disassembling the clutch from the motor, I noticed that the throwout bearing didn't have any type of clip holding it in. When I took off the pressure plate, the throwout bearing just fell off. Please note the clutch otherwise seemed to be fine.
Is there supposed to be a circular clip that holds it in? Pelican has 2 diagrams of this part, for various models.
This one:
Pelican Parts - Product Information: 950-116-080-08-M38
shows clips...
This one:
Pelican Parts - Product Information: 930-116-081-11-M38
Doesn't....
Do I need a circular retainer clip? The throwout bearing does move around a bit, but there is no way for it to fall out while the clutch is together. If I do need a clip, where can I get one??? Pelican states they are no longer available...
Thanks,
bo