|
It has a rubber mounted clutch, which looks pretty new. The thickness was 9.8mm or so, as I remember. It pretty much looks new.
What concerns me is that the clutch kits seem to show lots of parts holding the throwout bearing in place. This is the first 930 trans I have had out, so I just want to make sure the PO didn't leave parts out.
The throwout bearing does seem to have some wiggle room when the clutch is assemble. I can move it left/right/up/down about 3-4mm. I suspect that when there is tension on it, it wouldn't move. The throwout bearing didn't squeal or make any odd noises with use...
The clutch seemed to disengage fine. Occasioanlly it dragged and trying to put it in reverse caused some grinding, so I replaced the guide bearing "just in case", though I susepct it was fine. Perhaps the clutch needed adjusting...
Perhaps I just shouldn't worry about it?
Bo
|