Quote:
Originally Posted by JAR0023
Loosen the strap that secures the fan housing. Wiggle the housing back. Just grab with one hand on each side and it should slide back. Retighten to 18ft-lbs. How is the gap at the bottom of the fan housing in relation to the crank pulley? If the housing is too far to the rear of the car it can rub the crank pulley. If you search there are some good photos of this.
ETA if you want to cap the hole where your heater tubes connect you should be able to find a cap at any hardware store with a decent plumbing supply.
J |
I loosened the strap and got everything lined up. Now I just need to keep an eye on my belt tension to make sure its not too tight or loose. I put the heating system back together, now if only I could figure out how to activate the blower without also turning the starter...