[86 911 Targa]

Originally Posted by ericsinaus

I have successfully connected up the cables to the servo motor and rear red heater flapper box's but I have found that there are 2 wires that are not connected.

Someone previous to me seems to have messed with the car and removed or disconnected wires so Im not sure what goes where.

Can someone provide answers to the following please:

See on photo that there is a white and black pair of wires sheathed in a stiff white sheath that are sitting above the 2 yellow wires. It appear that at one end they run to the left rear red heat flapper box adjacent to the wheel arch.

Q1. What are the function of these 2 wires connected to on the flapper box. Is it a temp sensor or position control micro switch?

Q2. Where do these 2 wires connect to in the control unit. Everything seems to have a plug in it and appears to be connected except for 2 connections at a white plastic socket with square receptacles sitting above the brown wire in the far right right lower corner of the control unit which obviously is upside down.

Q3. If the white black wires do connect here, which colour wire goes into which socket?

thanks

Eric

Let's see if this helps.



Gerry