Pete... '80 dash connections below. Not sure if your '84 is same.
White arrows = 7 x 10 mm nuts
Black = 5 phillip head screws (windshield must be out as Dave mentioned to access these screws)
Orange = 5 plastic prongs
I removed nuts on driver's side of AC vent through instrument holes. Passenger side nuts through trunk going in behind the air handler box. Oz mentioned removing air box... since he was going to anyway, OK... but not necessary. (No offense Oz.) Toughest nut to reach is one on passenger side nearest AC duct but it's doable. Plastic prongs I cut off below deck but later discovered this might not have been necessary. Screws that secure forward edge of dash are about 2" away from prongs so I re-installed dash not caring about replacing prongs.
Pulled mine for dash recover using epoxy gel as adhesive...
Recovering Dashboard Using Epoxy Gel Adhesive
__________________
Karl ~~~
Current: '80 Silver Targa w /'85 3.2. 964 cams, SSI, Dansk 2 in 1 out muf, custom fuel feed with spin on filter
Prior: '77 Copper 924. '73 Black 914. '74 White Carrera. '79 Silver, Black, Anthracite 930s.
Last edited by Discseven; 10-25-2014 at 04:30 AM..
Reason: Clarity
|