Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Porsche Forums > 911 / 930 Turbo & Super Charging Forum


Reply
 
LinkBack Thread Tools Rate Thread
Author
Thread Post New Thread    Reply
Registered User
 
Join Date: Jan 2006
Posts: 62
Confused about 'improved' operating shafts

I am so confused. I am trying to put together a G50/50 setup. I am working on getting the operating shaft/clutch release put together. There are apparently two different operating shaft ‘improvement’ kits.

I have bits of both kits I think.

I have an operating shaft, needle bearings, plastic cap, etc I purchased from Pelican, it’s the OEM ‘improved operating shaft’ setup. I did not purchase a release fork, I already have that.

Then I have another operating shaft. It looks different. Machined steel. It’s the same as the one in the ‘other’ improved upgrade kit. This is the kit that says no drilling required.

If that kit updated operating kit says no drilling required, and the other does not. Then other must require drilling. Drilling what?

Jeff
Old 06-15-2007, 03:13 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #1 (permalink)
Reply

Thread Tools
Rate This Thread
Rate This Thread:

 


All times are GMT -8. The time now is 05:44 PM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.