need 14 pin connector help

[inaminit]

I am helping a friend install his 76 930 engine in a new to him 76 930 chassis. The 14 pin connectors on both the chassis and the engine have been modified with lots of splices, some with mismatched colors or gauges. We are using the color foldout wiring diagrams to guide our work , but need help as to which color wire and pin go to each hole in the connector halves. Any help will be greatly appreciated!

[David]

I made some 14 pin drawings several years ago you should find with a search.

Here: EFI conversion

[heliolps2]

Engine Harness Wiring (14 Pin Connector)

6 wires off main harness terminate on engine sensors and switches

Pin 9 - Green / White
Oil idiot light switch – Right rear of engine on top of scavenger tube and check valve – (911-606-230-00-M85)


Pin 4 – Green / Red
Oil pressure sender - Right front of engine above chain box next to fan perch - (911-606-111-01)

Pin 9 – White /Green
Oil temp. Gauge sensor - Right Front just below and to the left of the oil pressure sender - (930-606-112-00)

Pin 10 – Red-Black / Yellow
Thermo Time Switch - Left timing chain cover Thermo time Switch - (911-617-117-00-M100)


78 930 Engine 14 Pin Connector

Pin 1 – Yellow - Starter
Pin 2 – Red / White - CDI Box (In 6 Pin CDI Connector)
Pin 3 – Green / Black – Oil Temp Gage
Pin 4 – Green / Red – Oil Pressure Transducer
Pin 5 – Yellow / Green – Back Up Lites (not on engine)
Pin 6 – Grey / Brown – Back up Lites (not on engine)
Pin 7 – White - Over Boost Switch
Pin 8 – Brown / Black – Air Flow Meter Switch
Pin 9 – Green / White – Oil Pressure Switch
Pin 10 – Red-Black / Yellow – Thermo Valve
Pin 11 – Blue - Voltage Regulator (not on engine)
Pin 12 – Black / White CDI Box (In 6 Pin CDI Connector)
Pin 13 – Brown / White – Charge Pressure Sensor
Pin 14 – Red – Alternator

Good luck sir

Helio Lopes

[mikedsilva]

Originally Posted by inaminit

I am helping a friend install his 76 930 engine in a new to him 76 930 chassis. The 14 pin connectors on both the chassis and the engine have been modified with lots of splices, some with mismatched colors or gauges. We are using the color foldout wiring diagrams to guide our work , but need help as to which color wire and pin go to each hole in the connector halves. Any help will be greatly appreciated!

I downloaded this diagram from somewhere on PP a while ago.

[inaminit]

Thank you all!