Throttle shaft bushings

[77turbocarrera]

Anyone know the location of all three of these plastic bushings? I found the 2 by the shifter and the parking brake, can't seem to find the 3rd one.

Thanks

[full quack]

There is the linkage arrangement right off the trans on the drivers side, takes 2 bushings there.

Then there is the linkage arrangement on the top of the engine near the triangle of death, takes 2 there as well.

Mark

[77turbocarrera]

Originally Posted by full quack

There is the linkage arrangement right off the trans on the drivers side, takes 2 bushings there.

Then there is the linkage arrangement on the top of the engine near the triangle of death, takes 2 there as well.

Mark

Just to be sure, I'm referring to #13 on the schematic. It shows 3 rubber bushings. It looks like there should be one near the gas pedal, but I don't see anything that would hold a bushing.

Thanks

[s5uewf]

Is it possible these are the two you have found and one more near the rear bulkhead where the cable exits the pan? Not sure as I have not pulled my throttle cable before, but the schematic looks that way to me.

[full quack]

Looking at the exploded view, it looks like #13's are the rubber grommets for sealing/supporting the throttle cable as it passes alone the pan tunnel. The #12 is the dust/water boot where the cable exits the pan, right above the torsion bar housing tube in the rear.

The pivot shaft bushings for the gas pedal assembly are #28 at the pedal assembly drawing.

The lowest drawing is from the transfer position at the tranny on the drivers side.

Mark