|
|
|
|
| Author |
|
|
Registered
Join Date: Apr 2010
Posts: 2
|
2.7 rebuild
The engine is almost done, I was doing a piston to valve clearance check:
I get 1,1/2 turns on No.4 exhaust adjustment screw. Cams are 2.55 grind, pistons CIS, case and heads have been machined. Do I need to tear this side of the motor down ? Let me know what you think! |
||
04-11-2010, 10:47 AM
|
|
|
Registered
Join Date: Oct 2008
Location: Nash County, NC.
Posts: 8,515
|
The thread pitch is 1mm on the adjusting screw.
Bruce |
||
|
04-13-2010, 11:46 AM
|
|
|
Registered
Join Date: Apr 2010
Posts: 2
|
Understood, so the question is will I have a problem with 1.5 mm clearance on the exhaust valve?
|
||
|
04-13-2010, 01:43 PM
|
|
