![]() |
|
|
|
Registered
Join Date: Apr 2006
Location: northeast
Posts: 4,527
|
84' carrera intake manifold base barrel nut torque spec
I had to replace the intake gaskets on an 84' carrera & i cannot find the torque spec for these nuts...any one know what it is...?? thx, bob
__________________
I live for 911 tweaks... |
||
![]() |
|
CDN Redneck
|
Just went through the Bentley for that year and cannot find anything on it. However, the heat exchangers underneath are attached using 25nm or 18 ft/lb.
The Porsche Tech & Spec Manual by B.Whittier has no info that I can see either. Perhaps I have missed something in the Bentley but I hope the torque on the H/E is close
__________________
84 Carrera Coupe 3.2L Tea Tray Tail Black on Black |
||
![]() |
|
Registered
|
18 ft/lbs (page 102-37 in the Bentley)
__________________
Steve Sapere aude 1983 3.4L 911SC turbo. Sold |
||
![]() |
|
CDN Redneck
|
![]()
YUP!!! that is the correct torque, but it is on page 102-38 in my Bentley.
__________________
84 Carrera Coupe 3.2L Tea Tray Tail Black on Black |
||
![]() |
|
Registered
Join Date: Apr 2006
Location: northeast
Posts: 4,527
|
thx guys..I went with wayne's spec sheet aka torque listing on pg 200 of this book...at the bottom...generic m8 fasteners @ ~ 19#'s is what I set them to...
thx again & I am glad to know I did it correctly w/ you all confirming here...bob
__________________
I live for 911 tweaks... |
||
![]() |
|
Moderator
Join Date: Dec 2001
Posts: 9,569
|
Crosspost
merge with technical forum thread
__________________
'66 911 #304065 Irischgruen ‘96 993 Carrera 2 Polarsilber '81 R65 Ex-'71 911 PCA C-Stock Club Racer #806 (Sold 5/15/13) Ex-'88 Carrera (Sold 3/29/02) Ex-'91 Carrera 2 Cabriolet (Sold 8/20/04) Ex-'89 944 Turbo S (Sold 8/21/20) |
||
![]() |
|
![]() |