|
|
|
|
| Author |
|
|
911, 914-6, 928
|
Weber 46IDA base gaskets?
Which are the correct base gaskets for the 46IDA? Most listings are for 40IDA, and say to use them for the 46's too, but the bore is too small for a proper fit. Scarfing them out seems crude if the right ones are available somewhere.
Steve Last edited by Cornerlot; 08-04-2016 at 04:52 AM.. |
||
08-04-2016, 04:34 AM
|
|
|
Puny Bird
Join Date: Nov 2002
Location: Port Hope (near Toronto) On, Canada
Posts: 4,566
|
__________________
'74 Porsche 914, 3.0/6 '72 Porsche 914, 1.7, wife's summer DD '67 Bug, 2600cc T4,'67 Bus, 2.0 T1 Not putting miles on your car is like not having sex with your girlfriend, so she'll be more desirable to her next boyfriend. |
||
|
08-04-2016, 05:31 AM
|
|
|
Schleprock
Join Date: Sep 2000
Location: Frankfort IL USA
Posts: 16,639
|
^^^ Yup that site gets their stuff from PMO so that's a good source for sure.
__________________
Kevin L '86 Carrera "Larry" |
||
|
08-04-2016, 08:55 AM
|
|
|
Registered
Join Date: Mar 2001
Location: Marysville Wa.
Posts: 22,419
|
Just lay the gasket on the intake port and take a sharp pocket knife around the inside in a carving motion. 5 minute job.
__________________
https://www.instagram.com/johnwalker8704 8009 103rd pl ne Marysville Wa 98270 206 637 4071 |
||
|
08-05-2016, 11:59 AM
|
|
|
Registered
Join Date: Jul 2012
Location: Simi Valley, Ca.
Posts: 265
|
What John said. X-Acto knife with a new pointy blade works very well.
Bob B |
||
|
08-05-2016, 01:49 PM
|
|
1970 Porsche 914-6
