I have this set of Pauter rods in my parts stash and I am not sure which application they are for. They are stamped 911 but they do not seem to fit with any of the 911 rod dimensions in the Pauter catalog. Each big end has the 911 stamp on one side while the other side is marked W1 through W6
Here are the measurements:
big end ID - 58 mm
small end ID - 22 mm
big end center-to-small end center length - 127 mm
weight with bolts and nuts - 570 grams
If I had to guess, I would say they are for use with a 3.2/3.3/3.6 crank and pistons using a 22 mm wrist pin.
Anyone else have any ideas?
