[mideastmafia]

COMPLETE INSTRUCTIONS FOR REMOVING NOSE PIECE (Between headlights)
*NO WELDING NECESSARY* (only hand tools)

1-) Pop the hood.

2-) Remove the 4 bolts/nuts at the leading edge of the hood when it's closed (as in where the hood's leading edge would be if it were closed).

3-) Raise the headlights, turn ignition off (better yet disconnect battery) but not the light switch, that'll make the headlight buckets close.

4-) Pull away the cover strips, (at the leading edge of the headlights when closed, as in where the leading side would be when they are NOT raised, the strips should just slide out) Take off the two nuts/bolts that you will see immidiately after removing the cover strips.
(on both sides!)

5-)Remove the pilips screw, and the bolt from (there's one of each), at each "indentation for headlights". The bolts point away, and screws point towards each other. You should see these bolts at this stage, look carefully, quite hard to miss...

6-) Slide the panel forward, away from the car.

There's 12 pieces of screw/bolt/nut that will be removed in total...

Installation should be reverse of removal, I presume you'd need to align the holes at the headlight bucket rest spaces, than align the nose piece with the hood and headlights, and finally tighten all bolts...

(not written by me)

SHAUN