[ClickClickBoom]

Originally Posted by bcgreen

I wanted to lean into it, but it was on jacks and I didn't want to knock it off.
I took the rotor off and a small piece of 2X4 placed against the stem, hit it about 3X That did it.

This. Take a bit of wood and place it on the distributor body, after greasing the o-ring, not the axle, medium taps, like starting a 16p framing nail sent my dizzy home. I used a 2x4 that I notched to fit over the shaft and ride on the body of the dizzy. Just make sure that the gear teeth are indexed and the body slides into the case to the o-ring, then use your tapping tool.