power commander 3 PCMIII

[jzp7]

I recently installed a remus full exhaust including supplied Wideband sensor from the PCMIII to replace factory cat and o2 sensor.

I went on website on followed directions for install.

Once the PCMIII was fully connected, the bike would turn over but wouldn't fire. Once disconnected it would.

I went through the connections to verify all connectors were seated properly and same result.

Any thoughts for trouble shooting or past experience would be greatly appreciated. Dont know where to start with hardware or tune or bad install or something simple overlooked etc.

Thanks all!

[Droptarotter]

This tells me the PCMIII is no good, maybe best to contact Power Commander to see about trying another one.

Cheers