Outboard motor help?

E38Driver · 07-09-2022, 06:47 AM

With all the knowledge this forum has I'm hoping someone can help me out. I have a 2008 Mercury outboard 150 two stroke fuel injected and I was doing maintenance on it and found a sensor that the tube is not attached to anything. I have added some photos along with a diagram and I have a manual for the motor but it does not show where the tube goes.

Any help would be very much appreciated,

Dave

E38Driver · 07-09-2022, 06:54 AM

For some reason the photos didn't load

E38Driver · 07-09-2022, 06:56 AM

Here is the end of the tubing.

Baz · Baz's Garage

Hopefully someone can help you here.

But also wanted to suggest you consider asking/joining a Facebook group for whatever kind of boat you have - or maybe another one that deals with outboards.

I joined the Mako group and it's very helpful and I get lots of information from it.

Good luck, regardless....nice clean looking motor. I could use that to replace my tired '89 Evinrude 150!

E38Driver · 07-09-2022, 07:42 AM

Good Idea Baz. I'll try that avenue as well. I figured that this place has a wealth of knowledge. I joined the hull truth but as a new member I can't post photos

Dave

asphaltgambler · 07-09-2022, 07:44 AM

Since it's fuel injection, it would need a barometric sensor. Thar appears to be it?

E38Driver · 07-09-2022, 08:26 AM

The parts manual shows it as a 0-100 PSI sensor. I'm going to finish the PM on it tomorrow and after I replace the water pump impeller I'll start it up and look for leaks. LOL

Dave