![]() |
|
Not school for me either.
|
no school for me, and to be honest, I'm not planning on working really hard either... :)
|
I have no intention of going to work if its not very busy....
|
Morning Y'all.
|
Morning, Rick.
|
morning, I want to nap.
|
Oh Boy!! Finally get to go play in the snow with the Rover.
Don't fore see any problems making in down to hallway to "the office." |
4:58 am. Time to get up. Running a little late this morning.
|
good morning. Its cold here but no snow.
|
7f here with a -19 wind chill.... Water is frozen, dads out trying to get heaters running in the well house...
|
Must be Glen lost his power...... haven't heard from him yet today.
|
hang in there!!!!!!!!
|
Power is still on in OKC as best I know.... They are getting pounded with snow and serious wind too. I think they are getting more fluffy stuff than I am....
|
Quote:
|
been looking at the news at lunch. you guys are in a world of hurt. I got my fingers crossed!!!!!
|
Lots of wind and snow.... Roads don't look too bad out in the west where I am at... But I don't have to work and I have no intention of leaving the chair in front of the fire...
|
smart thinking!!!!!
|
As long as the chair is not too close to the fire, I don't see what the big deal is. I doubt it will catch fire.
|
Will he notice in time?
Tune in tomorrow to find out of Sidney is half baked!!!! |
Good afternoon guys.
The electricity is still on, we have lots of food and enough beer to get me to Thursday. I just came in from an hour of shoveling. The snow has stopped but the wind is stupid fast. 30 to 40 MPH gusts. There is a lot of blowing snow. The drift at the bottom of my driveway is about three feet high in the street. I don't think I can smash through even going down without getting stuck. I have the parts of the driveway cleared off but with the wind blowing I suspect it was a waste of time. It is 10 degrees right now with the low forecast of 5. I may need Richard to come smash through the drift so I can get out. I doubt I will be going in to work tomorrow. |
| All times are GMT -8. The time now is 03:46 PM. |
|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website