Question on 964 front bumper assembling...

[x98boardwell]

Can I put in all lights (fog, turn signals, corner marker, etc.) in front bumper on a 964 prior to me putting it back on the car? Or do I have to install front bumper first then add lights?

Just trying to do this only once... Appreciate the help.

Cheers,
Bryan

[wachuko]

If I remember correctly, when I removed the bumper... all lights were kept in place. All you have to do is unplug the lights when removing... and then plug back when bumper is in place.

I am trying to see if I took photos... I don't think I did...

[x98boardwell]

Thanks for the quick response. That is what I was thinking but wasn't sure. If you had a picture it wouldn't hurt. Thx

[x98boardwell]

Question, Do I have to drill out the rivet that is holding the twin bolts to the bumper between the fog light and blinker? This is the rubber piece that separates the turn signal and fog light..

1) Here is a pic for reference. There are twin studs that sit behind that rubber stop where it bolts to, but there is a rivet holding it together.

Thanks,

[wachuko]

Originally Posted by x98boardwell

Question, Do I have to drill out the rivet that is holding the twin bolts to the bumper between the fog light and blinker? This is the rubber piece that separates the turn signal and fog light..

1) Here is a pic for reference. There are twin studs that sit behind that rubber stop where it bolts to, but there is a rivet holding it together.

Thanks,

Here you go:

964-bumperette-delete-diy

[x98boardwell]

Thanks!! That is helpful