|
|
|
|
| Author |
|
|
Registered
|
Carrera script spacing
Everyone, could someone that has a tail on their on car and the Carrera scrpit please mesure how far up it is from the bottom of the decklid. I have one from a 964 that I got from Pelican and I am going to put on my 86 as it has never had one (well atleast since the PO added the tail). I know the 964 one is smaller but I did not want to have to drill any holes.
Thanks, Bill |
||
10-02-2003, 12:33 PM
|
|
|
Friend of Warren
Join Date: Oct 2000
Location: Lincoln, NE
Posts: 16,492
|
Bill I could swear this question has been asked before and a search will probably turn it up.
__________________
Kurt V No more Porsches, but a revolving number of motorcycles. |
||
|
10-02-2003, 12:35 PM
|
|
|
Registered
|
good point, I usually do that, I think I just got dumber reading about the idiots on the crotch rockets, my bad.
Bill |
||
|
10-02-2003, 12:36 PM
|
|
|
Friend of Warren
Join Date: Oct 2000
Location: Lincoln, NE
Posts: 16,492
|
I found it. Turns out it is almost a 2 year old thread and I posted on it which must be why I remembered it. By the way the measurement you need is 7 and 5/8 inches from the bottom edge. Here is the thread: Location of Carrera script on '84 rear deck lid?
__________________
Kurt V No more Porsches, but a revolving number of motorcycles. |
||
|
10-02-2003, 12:39 PM
|
|
|
Registered
Join Date: Nov 2000
Location: AZ
Posts: 8,414
|
Bill-
Just an FYI, the larger '84-'89 Carrera badge uses adheasive tape as well (no drilling). Only the SC emblems (and earlier) were staked through the deck lid. |
||
|
10-02-2003, 12:45 PM
|
|
|
Registered
|
Thanks Kurt.
The search resulted in a bout a million threads, I am glad you were able to narrow it down for me. Bill |
||
|
10-02-2003, 12:46 PM
|
|
|
 |
| Thread Tools | |
| Rate This Thread | |
|
|
