|
|
|
|
| Author |
|
|
Registered
Join Date: Nov 2001
Location: WASHINGTON STATE
Posts: 2,886
|
Had a bunch if stuff done.
Different materilas turn out slightly different in finish: 
|
||
12-11-2004, 01:54 PM
|
|
|
Insane Dutchman
|
My experience is that what most people call cad plating is actually zinc dichromate or "yellow zinc". A few years back I asked for cadmium plating, the plater threw a fit but did it, and the parts came back quite a bit different than what you see in this thread or in factory parts. When asked, he told me that what I really wanted was zinc dichromate, which apparently is much less environmentally nasty and cheaper to boot. I regularly bring in a bucket of old parts and get them plated for $50 for the whole thing....good result. Plater is Wespen Industries in Calgary, Alberta.....ask for Bipin Bhat....
__________________
1975 911S with Kremer 3.2 1989 911 Carrera Project Car |
||
|
12-13-2004, 07:39 PM
|
|
1975 Porsche 911S Kremer 3.2
