converting to h1's

[}{arlequin]

i already have 4 relays running my h4's along w/ inline fuses, 10 and 12 gauge wiring etc... i'm not exactly clear where to start... h4's only have 3 wires going into the bucket, low, high, and ground.


^^ is this going to be in any way relevant to my h1's? the 4 relays control left/right low and high beams, each getting its own relay. since there are two bulbs on h1's, does this mean that each bulb gets 2 wires powering them? 3 if each bulb has its own ground? or do i use 1 common ground for both bulbs?

plenty of "how to's" w/ h4's but not much out there on h1's.

thanks.