|
|
|
|
| Author |
|
|
Registered
|
reassemblying CV joints
I took apart my CV joints to clean them... and am having trouble getting them back again. Don't want to use too much force. I have tried putting the inner holder on the axle, then pushed the ball bearings into the openings, then tried to get the outer ring onto all this. No luck. Any better methods?
I am starting to regret taking them apart about now.
__________________
77 911, 3.0L |
||
04-26-2007, 02:50 PM
|
|
|
Registered
Join Date: Feb 2006
Location: Ontario Canada
Posts: 2,947
|
well you gotta get dirty... put it all together outside the car, put it on the half axle, put the clip on and install in the car.
That's how I did it anyway , dropped the whole half axle and did it on the bench.
__________________
1976 Yamaha XS360 ( Beats Walkin') 1978 911 SC Targa ( Yamaha Support Vehicle ) 2006 Audi A4 2.0T (Porsche Support Vehicle ) 2014 Audi A4 2.0T Technik (Audi Support Vehicle) |
||
|
04-26-2007, 03:23 PM
|
|
|
Registered
Join Date: May 2000
Location: Los Alamos, NM, USA
Posts: 6,044
|
Courtesy of Early_S_Man:
http://volksweb.relitech.com/cvjoints.htm http://www.type2.com/bartnik/cvjoints.htm CV joint disassembly |
||
|
04-26-2007, 03:26 PM
|
|
|
Registered
|
just what I needed... thanks.
__________________
77 911, 3.0L |
||
|
04-26-2007, 04:07 PM
|
|
|
Registered
Join Date: Oct 2004
Posts: 15,612
|
|
||
|
04-26-2007, 04:37 PM
|
|
