|
|
|
|
| Author |
|
|
Registered
Join Date: Nov 2004
Location: Okayama, Japan
Posts: 1,342
|
Replacing turn signals without removing bumper ?
Been doing some searching in the archives and it seems like I need to remove the bumper in order to put in a new Turn Signal Assembly...But there were several posts that seemed to suggest it was possible to do this without removing the bumper...Anyone 'been there done that' and want to share some tips with me one way or the other?
Thanks 
__________________
Current Drivers - 2006 BMW 1 Series & MB E320 Wagon (new addition 1998 Mazda Roadster) EX - 1993 Porsche 911 Carrera 2 EX - 1979 Porsche 911SC TARGA EX - 1976 BMW 2002 |
||
05-09-2007, 12:32 PM
|
|
|
Registered
Join Date: Dec 2002
Location: Dahlonega , Georgia
Posts: 14,600
|
I have removed/replaced the front units on my 83SC without removing the bumper. It's tight in there but with the car in the air and the tire removed it's not too bad.
__________________
2002 Boxster S . Arctic silver + black top/int. Jake Raby 3.6 SS engine " the beast ". GT3 front bumper, GT3 side skirts and GT3 TEK rear diffuser. 1999 996 C4 coupe black/grey with FSI 3.8 engine . Rear diffuser , front spoiler lip with ducktail spoiler . |
||
|
05-09-2007, 01:04 PM
|
|
