Here we go again! Zuffenhaus MS RSR project...

[ktr6]

Steering wheel assembled and installed!

[ktr6]

Regulator panel for the engine bay. Remote start button added similar to the original.

[scootermcrad]

That's a neat little detail!

[ktr6]

Originally Posted by scootermcrad

That's a neat little detail!

Thank you, trying to get things as close as we can!

[b2524]

This was then…..

[esample]

Originally Posted by ktr6

Thank you, trying to get things as close as we can!

You’re not still working on that car!!??

-e

[ktr6]

Originally Posted by b2524

This was then…..

Great photo! Thanks for sharing, definitely a different time.

[ktr6]

Originally Posted by esample

You’re not still working on that car!!??

-e

Good to hear from you, hope you are doing well. Still working on this project....slow and steady. Getting closer though.

[b2524]

Originally Posted by ktr6

Great photo! Thanks for sharing, definitely a different time.

The only thing missing is a can of spray paint sitting on the roof.

[j911brick]

Originally Posted by eimkeith

Also finished up proofing an alignment tool for installing 930/RSR pickups on the G50 torsion bar:





We're printing the weld-on bits for mock up this morning while I work on the chassis. Once proven out, we'll make some templates to transfer the cut lines to the steel stock and get the mounts made & installed on the tub.

I need this tool. Does anyone know where I can get one (or 2), or can anyone make me one?

[ktr6]

Hope everyone had a great Thanksgiving, wiring has begun!