|
|
|
|
| Author |
|
|
Registered
Join Date: Jun 2008
Location: IRELAND
Posts: 107
|
Connections on CIS Injection ??
Hi,
Can anybody point me in the right direction here with the wiring, This is the last job before i get the engine back in ! You can see in my clip that there is 2 blue and 1 black connecter, This is where im mixed up....there is 2 blue and the connections are the same, and then there is 1 black, so i figured that the black goes to the black ??? But then i was looking through the engine rebuild book and im pretty sure the Wayne had a picture of the black connecting into the blue !! Take a look at this clip and let me know.....  [IMG][/IMG] Last edited by P Moore; 09-07-2008 at 03:00 PM.. Reason: Spelling !! |
||
09-07-2008, 02:59 PM
|
|
|
Registered
Join Date: May 2000
Location: Los Alamos, NM, USA
Posts: 6,044
|
|||
|
09-07-2008, 03:54 PM
|
|
|
Registered
|
CIS Wiring connections......
P Moore,
From watching your clip, you got the right connectors for the following: Air sensor plate switch: brown and brown/red Cold start valve: yellow and red/brown Auxiliary air regulator: red/white and brown These are applicable to '76-'83 (911) CIS models. What year is your engine? HTH. Tony |
||
|
09-07-2008, 05:43 PM
|
|
|
Registered
Join Date: Jun 2008
Location: IRELAND
Posts: 107
|
I was trying to find this out .....
The casing has been replaced and there is no engine number....at first i was told it was a 2.7 but from pictures i sent to a friend over there he has told me that it is a 3.0 he said he knew this by looking at the flywheel ??? So do i have these connections correct ??? |
||
|
09-08-2008, 02:12 PM
|
|
|
Registered
|
Wiring connections......
Quote:
Yes. Based from the clip you have shown, the connectors are in the right spots. How about the 14-pin connector? If you need additional info regarding the 14-pin connector of the wiring harness just PM me. You should be ready for start-up. Tony |
||
|
09-08-2008, 03:12 PM
|
|
|
Registered
Join Date: Jun 2008
Location: IRELAND
Posts: 107
|
that should be ok as i never messed around with it !! I just took the loom off and kept it safe and re-wraped in tape,
Before i get her back in i have a MSD unit to install, i thought it would give me more room to install this when the engine is out, I have been told i needed the following: Msd - 6AL, Tach Adapter (msd) Then im waiting on the pertronix, ...getting rid of the points... |
||
|
09-08-2008, 03:55 PM
|
|
|
