Coffee/cup holder ideas?

[Benny771]

YA,YA, i know.
What are you doing dring a coffee in your P-car....
I drive a few hours away from time to time and would like to know what ideas prople have come up with for a coffee holder/ water holder.
Photo's a must, please.

The plastic ones that jam down the drivers window are out of the question for me. 1989 930 (should be the same set-up).

So what you got?

[mthomas58]

Lots of cup holder threads out there, Here's one with lots of pics

Best cup holder

[JMPRO]

Shameless plug
Pelican Parts - Product Information: PEL-JM-CUP

[daepp]

I was actually taking pictures of my newly wrapped whee, but if you look low you can see my cup holder. It holds two, even those with handles. It is made from bent wire/steel and follows the curves of the tunnel on either side and fits under the amts for wide stability. Nearly perfect, unless you slide the seats a lot. Sorry for the poor photos:

[tangerine911S]

[PCA7GGR]

Brian,

I hear that you can get the "roll" cupholder in various colors other than black. Is it also true that it tends to cling to a flat surface to prevent your drink from wandering.

[FastCarFan]

Originally Posted by tangerine911S

This is the answer. I tried the "hang on the door" types (kept falling off) & the "bar buoy" type (moved around so much the coffee spilled). Then I tried the duct tape. Works incredibly well. I put it on the floor in front of the passenger seat. My stainless coffee mug fits perfectly.

And when a passenger gets in the car I simply pick up the duct tape & put it on the floor behind the passenger seat.

Plus, I am ready for virtually any on-the-road repair -- duct tape can fix almost anything!

[paulgtr]

roll of duct tape between the seats works in my car

[iX_Xi]

At driver's door. Lower pocket just below hand grab should accommodate a starbucks cup 1/3-1/2 of the way, I can also wedge my travel mug (tapered bottom) in there. To keep it from sliding forward clip your garage door opener in the pocket just forward of the cup. This will also keep a can of soda from tipping over.

[Nine17]

This post has been up all day. I'll bite.

Option 1:


Option 2:

[911JC911]

[Wavey]

[twistoffat]

[kenikh]

Here's a link to the first one: Porsche Inventive Concepts Detachable Drink Cup Holder.

[ClickClickBoom]

Here is mine, its in a Toyota Landcruiser:

Made by Powertank, full swivel action!
Carry on
eric