![]() |
|
|
|
dazed and confused
|
Interference fitting heater tin
Any suggestions on ways of moving the camshaft oiler piping on the left side of the engine to allow clearance for the early version heater ducting would be appreciated. Its the last step in backdating my heat and i don't want to start bending small dia pipes in case there's an easier way.
__________________
89 Carrera 3.2 Targa 2011 BMW 335d 2013 BMW X3 3.5 80 911 SC Weissach Coupe (Sold) ![]() |
||
![]() |
|
Registered
Join Date: Mar 2001
Location: Marysville Wa.
Posts: 22,433
|
if your metal line is straight as it goes into the horizontal line, then there's another pair of lines that moves the attaching joint inward a bit. the metal line would have a bit of a S curve at the top.
__________________
https://www.instagram.com/johnwalker8704 8009 103rd pl ne Marysville Wa 98270 206 637 4071 |
||
![]() |
|
dazed and confused
|
Not sure I understand what you describe; attached is a photo of the oil line
![]()
__________________
89 Carrera 3.2 Targa 2011 BMW 335d 2013 BMW X3 3.5 80 911 SC Weissach Coupe (Sold) ![]() |
||
![]() |
|