part number please

[Packy]

Can anyone please tell me the part number for the pin that goes into hole where the green arrow is pointing?


Thanks,
-P

[pete3799]

Don't know the part # of the roll pin but you don't really need it.
I left mine out first time i dropped the motor.

[Packy]

Screw it. McMaster-carr it is then.

[Pazuzu]

For completion of the thread...
Pelican Parts - Product Information: 900-095-050-00-OEM

It's a 4mmx26mm "tensioning sleeve".

[Packy]

Originally Posted by Pazuzu

For completion of the thread...
Pelican Parts - Product Information: 900-095-050-00-OEM

It's a 4mmx26mm "tensioning sleeve".

No, that's the wrong one. This pin is too small. I don't think Pelican lists the other, bigger pin that goes into the throw out lever. I measured and the diameter of the hole is .195" x 1.275" or about 4.95mm x 32.4mm. McMaster sells a 5mm x 32mm as well as a 7/32 diameter pin that I'm going to buy.

Pelican should pick these up.

[Pazuzu]

Originally Posted by Packy

No, that's the wrong one. This pin is too small. I don't think Pelican lists the other, bigger pin that goes into the throw out lever. I measured and the diameter of the hole is .195" x 1.275" or about 4.95mm x 32.4mm. McMaster sells a 5mm x 32mm as well as a 7/32 diameter pin that I'm going to buy.

Pelican should pick these up.

Dammit, you're right, I'm retarded. FWIW, my car doesn't even have that pin, so it's not an issue

[Tidybuoy]

Is this for the '79 SC or the '97 Ford?