|
|
|
|
| Author |
|
|
Registered
Join Date: Dec 2002
Location: Redondo Beach, CA
Posts: 542
|
TOB Guide Tube hardware
Well, again I come to the forum with a tranny question:
What hardware (length/pitch/head/washers/etc.) holds the TOB guide tube on a G50? I've got the tube on the way from Pelican but the hardware was going to take too long to get so I have to look local (and get my car back on the road this weekend)! Figuring I'm probably going to do a bit of damage to the phillips heads during removal I'd like to replace with new but don't have the option of removing first to check sizes (car is in the mtns relatively far from any good harware stores). Can anyone help me out? Thanks folks! See you on the road Monday!
__________________
-Todd '89 930, '97 TLC (Toyota Land Cruiser), '96 T-100pick-em-up '95 BMW R100 GSPD (gone but not forgotten), '07 BMW R1200GSA |
||
02-27-2003, 11:00 AM
|
|
|
Schleprock
Join Date: Sep 2000
Location: Frankfort IL USA
Posts: 16,639
|
Todd,
You need only two screws and that's it. They're countersink head screws with standard M6 thread by 14mm length (M6x14)
__________________
Kevin L '86 Carrera "Larry" |
||
|
02-27-2003, 12:18 PM
|
|
|
Registered
Join Date: Dec 2002
Location: Redondo Beach, CA
Posts: 542
|
Perfect! Just in time. Kev, I owe you a beer or four. Thanks!
Cheers!
__________________
-Todd '89 930, '97 TLC (Toyota Land Cruiser), '96 T-100pick-em-up '95 BMW R100 GSPD (gone but not forgotten), '07 BMW R1200GSA |
||
|
02-27-2003, 12:26 PM
|
|
