Pelican Parts Forums
Page 2 of 2 « Prev 1 2
Show 40 post(s) from this thread on one page

Pelican Parts Forums (http://forums.pelicanparts.com/)
-   Porsche 914 & 914-6 Technical Forum (http://forums.pelicanparts.com/porsche-914-914-6-technical-forum/)
-   -   Which socket should I use to remove axle nut? (http://forums.pelicanparts.com/porsche-914-914-6-technical-forum/140273-socket-should-i-use-remove-axle-nut.html)

karlp 12-22-2003 11:03 AM
I'm with Mike95125, cut it.
I beat it, heated it, beated it and had enough torque on it to spin the wheel on the ground.
2 minutes with a die grinder I'd cut a slot long way, not all the way through, then hammer and big chisel and split it.

Paid $6 for a new one at the local motorcycle shop.



Karl P


All times are GMT -8. The time now is 06:02 PM.
Page 2 of 2 « Prev 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website


DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.