Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Porsche Forums > Porsche 914 & 914-6 Technical Forum


Reply
 
LinkBack Thread Tools Rate Thread
Author
Thread Post New Thread    Reply
Registered
 
Mike Kunz's Avatar
 
Join Date: Nov 1999
Location: Laguna Beach, California
Posts: 237
Garage
Send a message via AIM to Mike Kunz
Question Left Door Pocket Spring? Another Dumb Question...

Just noticed that my left door pocket should actually be spring loaded. I can figure out where the spring attaches to the lid, but where does it hook into on the door panel???



------------------
VOPO '74 2.0

Old 10-05-2001, 12:49 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #1 (permalink)
Registered
 
Join Date: May 2001
Location: Hurst, TX. USA
Posts: 804
Cool

Near the rear of the box there will be a little hole in the door pad with a washer crimped in it. The other end of the spring attaches through this hole into the door frame. Don't just hook it to the door pad, it will rip out the pad around the hole. BTDT.

Clay
Old 10-05-2001, 12:56 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #2 (permalink)
Administrator
 
Dave at Pelican Parts's Avatar
 
Join Date: Dec 1969
Location: Silly-Con Valley
Posts: 14,920
Garage
Send a message via AIM to Dave at Pelican Parts Send a message via Yahoo to Dave at Pelican Parts
Porsche Crest

I disconnected the spring the first time I pulled the door panels, and never bothered hooking it back up again. I don't think it needs it--gravity does quite a nice job of holding it down.

--DD

------------------
Pelican Parts 914 Tech Support

A few pics of my car: http://www.pelicanparts.com/gallery/Dave_Darling
Old 10-05-2001, 01:24 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #3 (permalink)
Senior Member
 
Join Date: Nov 2000
Location: Stuttgart FRG
Posts: 2,307
Post

Hello

The spring has two reasons:

keeping the door shut and avoid rattle and to keep the door open.

Its a bit tricky but if you remove the pocket and then hang the door in and screw it back on it mostly is the easiest way.
Yet angled nose pliers do work too.

Grüsse

Old 10-07-2001, 07:40 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #4 (permalink)
Reply


 


All times are GMT -8. The time now is 07:45 PM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.