|
|
|
|
|
|||||||
 |
|
|
LinkBack | Thread Tools | Rate Thread |
| Author |
|
|
Architecture & Porsche's
Join Date: Jan 2006
Location: Austin, Texas
Posts: 3,189
|
901 help! Replaced 1st gear, forgot to secure intermediate section!
I made a mistake!
I installed a 1st gear set on my 901 in my 914 & forgot to secure the intermediate section before I started loosening the 30mm & 17mm, dislodging the intermediate section from the main case by about 3/8". Because of this, I've misaligned the shift shaft (that protrudes out of the side of the transmission on the side-shift transmission that connects to the shift linkage) by doing this & cannot continue until I find out how to realign. Ive tried to find the alignment by moving the 30mm & 17mm back & forth & therefore moving the intermediate section back & forth, trying to get the shift-shaft back & forth, but no-go. I'm stuck. I HAVE To have the car off the lift by tomorrow night for a video shoot & do not want to have to tow it semi-disassembed 40 miles way to get it fixed: anyone?? anyone?? Mark
__________________
Porsche Club Racing National Scrutineer '89 Andial 951 '82 928R '74 911 RSR 3.6 |
||
04-19-2009, 07:04 PM
|
|
|
Registered
|
pull the shift console and use a big screw driver to put all the rods back in nuetral position.
|
||
|
04-21-2009, 07:04 AM
|
|
|
Architecture & Porsche's
Join Date: Jan 2006
Location: Austin, Texas
Posts: 3,189
|
That's what I ended up doing last night with some direction from some local folk. Thanks!!
|
||
|
04-21-2009, 07:19 AM
|
|
|
| Thread Tools | |
| Rate This Thread | |
|
|
74 Porsche 914 2.0L 
