Looking for source of 914 piston

[Suter]

Hi All,

Picked up a 914 project and am looking for a piston for the engine. All I have to go on are the pictures attached, the only markings present are shown "OE" on the underside of the piston. I'd like to buy only piston as the engine had been rebuilt just before it dropped a valve and broke up one of the nice, new pistons...
It's a 73 2.0, I think this is an overbored size. Seems to be a high-performance piston (nikasil coated, flat-top, short skirt).
Photos are of one of the good pistons BTW.
Thanks in advance,
Les

[80-911SC]

I would place WTB in the classifieds here and the world ... you are going to need to figure out the exact size cylinder you have so you can match the piston you are looking for ... last resort would be samba but they tend to hit for a premium price ....

you may have an issue though needing one of due to the fact that its going to need to be the same brand etc ... or you may throw the balance off in the engine .. some of the experienced builders may be able to ID it from the markings ........

Steve