|
|
|
|
| Author |
|
|
Registered
|
oxygen sensor
I am installing an air fuel ratio meter....in my 84 928 S, i have located the leads to the oxygen sensor...two wire connector--the heater wire? and thick green wire---signal wire to computer? i believe i should tap into the green wire..BUT, i am getting no power to any wire, with key turned on. ( engine not running) PLUS the green connector was broken and disconnected too when i found it!!! can anyone shed some light on this dilemma? thanks JIM
__________________
1985 944 |
||
07-20-2007, 05:36 PM
|
|
|
Network Native
Join Date: Jan 2007
Location: SoCal
Posts: 10,349
|
Its good to lay out all the details of what you are installing, as it may have issues that are known. Which meter, sensor, etc.
__________________
US 83 zinc metallic 5 spd, aka the nice car. Euro 85 black, 5 spd, the fast rough track car maybe car. SOLD Euro 84 red, AT, only car in garage in years, my parts car, soon to go last 7 years. |
||
|
07-20-2007, 06:04 PM
|
|
 |
| Thread Tools | |
| Rate This Thread | |
|
|
grey ghost
dream car!!!
blk bullet
