[woodex]

Hi all,

I flushed the brake system on my r1100s last year. Followed detailed procedures online to the letter. Everything went well and successful ABS initialisation on key turn worked every time. Brakes where fine when riding.

It was garaged for a while but recently took it out, fitted a new battery and turned the key...

Usual ABS initialisation begins but the servo just doesn't stop and just keeps whining away so never completes the initialisation.

I've checked brake fluid levels at abs box and levers and all good
If I use front and rear levers I can hear a click on lever switch and inside abs box.
Both levers operate brake light.
Both levers cause an audible change in abs servo tone when used during the everlasting initialisation procedure
Checked brake pistons and they are not seized.
Checked all lines and everything seems fine

Anyone had a similar problem or provide any other options to check out?

much appreciated