|
Steps involved:
1. Print the parts
2. Remove the door strikers for each side
3. Use a vice, a 10mm socket and a small finishing nail.
3.a. Put the socket on the door sill side of the striker and use the nail against the outside to press out each pin, using your vice as the press.
4. Rotate the plate face (might need some percussive force here, suggest rubber BFH)
5. Remove lower buffer
6. Replace lower buffer with printed buffer.
7. Re-align face plate of door strike closing unit
8. Replace the pins you pressed out on step 3/3.a
9. Reinstall door strikers with rebuilt striker buffers
10. Open a beer while you close your 911 door
Hope that helps someone in a jam like it did to get me through that moment.
|