[keitho64]

I have a pair of Recaro seats that were in my 1969 911 and I am planning to install them in the 996. On the old 911 the seat belt receiver was connected to the chassis of the car. I noticed on the 996 the seat belt receiver latch is bolted to the factory seat.

For reference my factory seats are power, no lumbar, no heat. There is a module under the seat that connects to the motors as well as a small connection to the seat belt latch.

For those of you who have done this mod I have a few questions.

Where did you mount the seat belt receiver? to the slider? to the seat? to the chassis?
If you mounted it to the slider, did you add a bracket to bolt the factory receiver to?
Did you reconnect the seat belt harness?
Did you have an issues leaving the module mounted to the floor?

Thanks in advance!