Yes it sure would have been nice if KW had addressed this on the lowered spindle...
Quote:
Originally Posted by shoooo32
It would be interesting to see if you could bend it enough to eliminate the need for a kit and not affect the geometry. Would the tie rod hiem have enough articulation to make up for the hole being on an angle? I have a junk spindle laying here - might be a fun experiment
|
One problem with bending the arm is that you change the lever and therefore the steering effort.
I would do it like Jonny did, combine steering rack spacers (I think you can fit 10-11mm ones without creating interference) with a proper bump steer kit. The height of the spacers you then need on the spindle arm is so short that the forces will not be able to bend the bolt.
Cheers,
Lukas