I have an intake that began life as a 964 intake. It was modified and then covered in Kevlar for strength under boost. This is the plastic design so it outflows the aluminum version. It has less heat soak especially with the kevlar wrap. I was going to paint the intake to match my car. Most people are seeing about 40-50+rwhp from this intake over a worked 3.2 intake. This intake will set you apart from the run of the mill intakes. Project went another direction so I am selling it. I will take 750 plus shipping for it. Way more than that in it including time. It is the intake halves not the center section. Marco at Billet Design built the intake and has an extra center section to finish off the project. It would be set up for a mustang throttle body. Big power potential here!
Thanks
Eric Hood
