Rimmy, I did not mean to imply that you were trying to get something for nothing here. I fully realize your excitement at the prospect of possibly being able to make your own parts. I sure wish I was in that position myself. You would most likely find that the setup and fine tuning required for one set of parts would be worth way more than the $500 I was charging for these complete sets of clamps. Some of my early machine quotes were in the range of $3000 for one set of parts. Mike (captainasty) and I have been through a lot getting these parts dialed in and we would not want to have to go through some of that stuff again. There's a lot to be said for experience gained on a project like this.
At any rate, I appreciate your enthusiasm for these clamps and am going to post up another opportunity to purchase a new set of clamps later today. Check back on a new thread I will be posting for more R1100S clamp sets.
Here is the link to the new thread for more triple clamps:
Custom Triple Clamps 2nd Edition