[ajserrano]

Hello!

Does anyone know who may have a "Celette Fixture Bench Frame Jig" that is located in Southern California? (Porsche capitol of the world!) lol

My 914-6 GT project is now on-hold until a make a small .25" inch correction to the frame so that we can continue and install the steel reinforced GT Targa-Top and roll-bar. See links below...

Here is the 914-6 GT Targa Top http://www.pbase.com/9146gt/image/86736092

This link shows us the rear-right corner of the targa top http://www.pbase.com/9146gt/image/88800843 while fully inserted towards the front windshield frame, here is a closer look http://www.pbase.com/9146gt/image/88800846 showing the problem.

Here we see the opposite side of the targa-top showing an overlap http://www.pbase.com/9146gt/image/88800847 and here is a better angle of this side http://www.pbase.com/9146gt/image/88800853

Also, the roll-bar installation is now almost complete but we cannot proceed with the welding of the forward tubes until we know the chassis is true and square. See here http://www.pbase.com/9146gt/image/98971114 and http://www.pbase.com/9146gt/image/98971143

If you know anyone that may be able to offer some assistance or can provide any leads on may have access to a Celette Bench Jig with the proper 914 fixtures, please email me the information at ajserrano@msn.com

Thank you all in advance.

Armando

PS: Interesting article and comments about using a Celette Chassis Jig can be found here http://www.356registry.org/Tech/celette_jig.html