[DSPTurtle]

I always have to press them off on my hydraulic press. You could get a smaller diamter socket and suspend the axle while you hammer on the shaft end. Becareful to make sure you are grabbing the inner portion of the joint and not the outer. Acutally it is easier to jsut take the outer portion apart. If you do that you will find it a lot easier to fight with the pressed on inner portion of the joint.
I can't find a pic on this computer from the last three sets that I did but I am sure someone will post something.
Also, remember the puzzle when reassembling... little portion of outer lines up with big portion of inner. Hopefully you have done these before. If we can't find a pic I will hunt on a different computer so you can see what I am talking about if you need it.