was rebuilt back in 11/03, I have a copy of the shops receipt. Long story short, I purchased the car from back east and could not get it registered because it had a re-titled vin number, and no other supporting vin number, so the car was parted out. I was going to use it in a 1980 that I am building, but decided to go with a 3.6 conversion. Has a cat bypass, and Dansk stainless steel 1 in 2 out muffler that is almost new. The cat was plugged so it discolored the one side, then the cat was removed and a bypass put in, the 2 tips still need to be installed, but are included. Has new intake and injector seals, pop off valve, carrera chain tensioner upgrade. Dist. had been removed, so it needs to be put in and indexed correctly, New braided Beru plug wires, New Bosch coil. It only has about 2-300 miles on it since it was rebuilt, but looks like 1 of the throu bolts was leaking and they tried to put JB weld over it to stop the drip. Comes with clutch adn PP that look new (no ring gear), and fuel accumulator.
The fan does have 2 chips inthe back, and the fan housing does have a few cracks, one accross the mounting bolt for the coil that was helicoiled, but it still functions fine
NOW PARTING
78/79 Engine shroud $75
78/79 Fan housing (not perfect, but works) SOLD
78/79 Fan (1 chip in back, a little worn on hub corners ) $125
Alternator air deflector $50
Valero Alternator, int. reg. works good $SOLD
Complete CIS intake 78/79 large port $700 obo(includes 2 new straps, K&N filter, Carbon Fiber cover(pictured), and stock cover)
engine wiring harness, working, but some wire sheathings are cracked $120
Upper Valve covers $75 pair
Lower turbo valve covers $SOLD
Cam Towers $100
pr (1972 3 bearing towers)
3 bearing Cams $BO
Rockers $120 set
Cam hardware $40 pair (have 2 pairs)
Chain Cases $80 pair (have 2 pairs)
Carrera Tensioner kit, complete SOLD
Oil Pump $240
78/79 Distrubutor w/ new green signal wire $SOLD
NEW spare Distributor Signal Wire $50
almost new Beru braided plug wires (0 miles on them) SOLD
almost new Bosch coil and bracket $70, put on with wires, but never run
Thru Bolts/nuts/washers $50 set (I have 2 sets)
Rods $200 set
perfect Crank w/ nose bearing $900
Intermediate shaft $75 (also have another one from a 80 motor)
78 Case $800 (also have a 80 case in another ad that needs a stud removed and had part of the alt cradle welded for $450)
78/79 rebuilt heads, w/air injection block offs. $750
Nikasil Piston and Cylinders $500
24 Head Barrel nuts and washers, used, but look new $50
Dansk polished stainless sport muffler 1 in 2 out, SOLD
Catalytic converter bypass pipe $SOLD
Cylinder head air defector tins $50 set (have 2 sets)
Flywheel $75
Pressure Plate and Clutch $?
Engine support bar and cradle $125
Fuel accumulator and "S" line $75
Engine mounted oil cooler $150 ea(have 2)
Paypal payments are fine.
Shipping not included
I ONLY ship FEDEX, your package can be tracked at any time, and IF a claim needs to be made, It is way easier than dealing with a government agency!
