[aigel]

Well, I went and took the control board out to check for any cold solder joints. Tested a few of them for continuity including the solder joints of the connectors. Nothing found. I put the board back in and the sucker now runs. Doing a load of laundry as we speak.

It may be far fetched, but the board is grounded with 2 screws. It could well be possible it wasn't grounded well before as there was a slight leak in there for a year or so before I fixed that.

Keep your finger's crossed. If this load of laundry goes through, it will be back against the wall and run until it goes again.

Cheers,

George