[kfray]

If you do not have ABS this will work. Follow the brake wear sensor wiring from each of the 4 wheels you will find a round connector clamped to the chassis, for example near the top of the strut in the engine compartment. On the other side of these connectors the wiring consist of only 2 wires. I cut the connectors off and soldered the 2 wires together and covered with heat shrink or electrical tape. The break wear indicator is looking for continuity of between these 2 wires, for each brake(4). I removed the brake wear sensor wiring up to and including the large round connectors. You will have to check your brake pads for wear your self.