[A horse with no name]

Originally Posted by DRACO A5OG

It is possible but really what you want to do is measure the angle of the plate prior to removing it. Upon install, make sure the angle is the same.

Hi Jim, I should have included your info. I do have a angle finder.
I have read numerous posts over the years re the indexing of these rear torsion bars but I have never read one where it was suggested to punch mark the end spline and the inner bushing housing for reassembling. To me it should work. I tend thought to wonder that with the numerous threads on the subject that it may not work.

This brings up another question. With the bushing worn, is the current spring plate angle the same as they were when new? - Or?