Quote:
Originally Posted by ARad
Any update?
|
Yes. I took in material to have 10 arm end cut. the issue was bending the 1/4" steel with tight 45 degree bends close together. I found a 13mm diameter, 5mm thick bearing that is smaller 17mm bearing I had used in the other shorter shafts. The smaller bearing will allow more area between the big holes. If they still have problems getting the offset I will make it with a straight arm end and use a 28mm spacer. Trying to minimize parts and keep cost down. The longer spacer costs $12 each.
Should have samples back soon. Then drill holes, welds up and surface finish.