Random TRANSPORTATION pictures - Page 446

URY914 · URY914's Garage

Jim Bremner · 03-15-2011, 08:54 PM

Quote:

Originally Posted by cashflyer

Contra-rotating propellers, also referred to as coaxial contra-rotating propellers, apply the maximum power of usually a single piston or turboprop engine to drive two propellers in opposite rotation. Contra-rotating propellers are common in some marine transmission systems, in particular for medium to large size planing leisure craft. Two propellers are arranged one behind the other, and power is transferred from the engine via a planetary gear or spur gear transmission. Contra-rotating propellers should not be confused with counter-rotating propellers—airscrews on different engines turning opposite directions.

When airspeed is low the mass of the air flowing through the propeller disk (thrust) causes a significant amount of tangential or rotational air flow to be created by the spinning blades. The energy of this tangential air flow is wasted in a single-propeller design. To use this wasted effort the placement of a second propeller behind the first takes advantage of the disturbed airflow. The tangential air flow also causes handling problems at low speed as the air strikes the vertical stabilizer, causing the aircraft to yaw left or right, depending of the direction of propeller rotation.

If it is well designed, a contra-rotating propeller will have no rotational air flow, pushing a maximum amount of air uniformly through the propeller disk, resulting in high performance and low induced energy loss. It also serves to counter the asymmetrical torque effect of a conventional propeller (see P-factor). Some contra-rotating systems were designed to be used at take off for maximum power and efficiency under such conditions, and allowing one of the propellers to be disabled during cruise to extend flight time.

Contra-rotating propellers have been found to be between 6% and 16% more efficient than normal propellers.[1] However they can be very noisy, with increases in noise in the axial (forward and aft) direction of up to 30 dB, and tangentially 10 dB.[1] Most of this extra noise can be found in the higher frequencies. These substantial noise problems will limit commercial applications unless solutions can be found. One possibility is to enclose the contra-rotating propellers in a shroud. It is also helpful if the two propellers have a different number of blades (e.g. four blades on the forward propeller and five on the aft).

The efficiency of a contra-rotating prop is somewhat offset by its mechanical complexity. Nonetheless, coaxial contra-rotating propellers and rotors are moderately common in military aircraft and naval applications, such as torpedoes.