|
|
|
|
|
|||||||
 |
|
|
LinkBack | Thread Tools | Rate Thread |
| Author |
|
|
It took only 49 years!
|
FS from 1987 Carrera: Fully Functioning Factory A/C Evaporator and Front Condenser
I recently upgraded to Kuehl units so these factory-installed A/C items are for sale. They are fully functioning and will be cleaned and fins straigtened before shipping:
Front Condenser  Evaporator  Asking $200 shipped OBO, Paypal Personal Gift option. For more info or photos, email me: bluerex02 at yahoo dot com I also have a stock 20mm front swaybar off of a 1985 Carrera, $60 shipped.
__________________
Serge: In the heart of Philly! Daisy - 1972 911T 2.7L Light Yellow Veronica - 1987 911 Carrera Coupe Indischrot, M&K GT3 muffler and Euro Pre-Muffler, SW Chip SOLD  Lil Blue - 2002 Subaru WRX Wagon (my dd/HPDE car) SOLD
Last edited by mclmk8d; 10-04-2012 at 04:17 AM.. |
||
07-12-2012, 11:36 AM
|
|
|
It took only 49 years!
|
Road Trip Bump and Price Drop
Both Parts for $150 shipped...I will be check the board and emails.
__________________
Serge: In the heart of Philly! Daisy - 1972 911T 2.7L Light Yellow Veronica - 1987 911 Carrera Coupe Indischrot, M&K GT3 muffler and Euro Pre-Muffler, SW Chip SOLD Lil Blue - 2002 Subaru WRX Wagon (my dd/HPDE car) SOLD
|
||
|
07-16-2012, 04:39 PM
|
|
|
It took only 49 years!
|
Thursday bump for these parts
__________________
Serge: In the heart of Philly! Daisy - 1972 911T 2.7L Light Yellow Veronica - 1987 911 Carrera Coupe Indischrot, M&K GT3 muffler and Euro Pre-Muffler, SW Chip SOLD Lil Blue - 2002 Subaru WRX Wagon (my dd/HPDE car) SOLD
|
||
|
10-04-2012, 04:18 AM
|
|
|
Registered
|
Payment sent for front condenser
|
||
|
10-04-2012, 10:34 AM
|
|
|
It took only 49 years!
|
Condenser is SOLD.
Evaporator still available for $80 shipped
__________________
Serge: In the heart of Philly! Daisy - 1972 911T 2.7L Light Yellow Veronica - 1987 911 Carrera Coupe Indischrot, M&K GT3 muffler and Euro Pre-Muffler, SW Chip SOLD Lil Blue - 2002 Subaru WRX Wagon (my dd/HPDE car) SOLD
|
||
|
10-06-2012, 10:47 AM
|
|
|
Registered
|
Got the condenser last night, exactly as shown in the pic.
However, "will be cleaned and fins straigtened before shipping" did not happen. What kind of degreaser were you intending to use to clean the condenser? What do you recommend? |
||
|
10-13-2012, 05:16 AM
|
|
|
|
Registered
|
If you feel like spending the bucks you can use a dedicated AC refrigerant flush to flush through evaporator's and condensers tubes, or simply mineral spirits. However what ever you use inside the units must be thoroughly evaporated before you install in the vehicle and charge with refrigerant. Same goes for the exterior of the condensers or evaporators; you can also use on the exterior any water based degreaser and once again wash thoroughly to remove residual cleaner: make sure you do not allow water to enter inside the units.
For straightening of the fins, which "normally" due get bent in transit or when you handling them, a good pair of mechanical tweezer's (point ends) works fine; and a pint of Becks with patience. A light shot of spray paint on condensers offer's copper coils a bit of corrosion resistance, however aluminum coils and fins normally form their oxide on the the surface which is a natural barrier. Don't paint evaporators. Be sure your battery is not dripping acids down on the front condenser; white residue on the condenser or grill is a tell tale sign. |
||
|
10-24-2012, 03:02 AM
|
|
|
| Thread Tools | |
| Rate This Thread | |
|
|
Veronica
Lil Blue
Daisy
