need left rear trailing arm

[rotor562]

I need a left (driver) rear trailing arm for a 75 914. I overtorqued one of the nuts for the long bolt or pin that goes on the attaching points and sheared it. Im in los angeles and can be reached at 562 324 3408

Thank you

[b2524]

sounds like you need the pivot bolt. they come out but it is not easy.
you need to pull the arm down and put a puller on the good end.
it will take some work but you can replace them, you will need new polygraphite bushings to replace the rubber ones.
if you don't want to do that i have an arm and can bring it to the swap meet this weekend or you can probably find one there.
kd

[jeffs9146]

Originally Posted by rotor562

I need a left (driver) rear trailing arm for a 75 914. I overtorqued one of the nuts for the long bolt or pin that goes on the attaching points and sheared it. Im in los angeles and can be reached at 562 324 3408

Thank you

All you need is the shaft that goes into the trailing arm! I might have one sitting around, I will check!

PS: It presses out of the bushings! You press it in until it is free of the bushing and put a screw driver between the arm and the edge of the bushing to pop it out. Then turn over the arm and press the shaft back in and through the other bushing until the bar pops out! Installation is reverse and very simple.